Siemens 1PH818 Operating Instructions & Installation Instructions page 146

Service Instructions NFF
Electromagnetic Double Face Spring – Applied Brake
Caution! In every case the local safety and accident prevention regulations are also
applicable, the user must ensure that these are complied with.
We reserve the right to make modifications of a technical nature to this manual if required for
brake development.
We recommend that these instructions are incorporated into the service manual of the user
(machine manufacturer).
2.4 Electromagnetic Compatibility
The Electromagnetic Compatibility of Equipment Act (EMVG) demands to meet defined
protective requirements when using electrical equipment so that this equipment can operate in
its electromagnetic environment without mutual impairment of function.
Machine manufacturers, system and plant constructors must assure that the product is installed
as required and that the installation of the pertinent current supply is made correctly in order to
adhere to the protective requirements of the EMVG.
Please inquire our leaflet "EMC - notes", No. 900 - 00001 at Stromag Dessau GmbH; address
as per chap. 10.3.
3 Transportation
3.1 Packing
The type of packing complies with the agreements with the orderer as stated in the order
acknowledgement. If no type of packing has been agreed, it depends on the transportation
route. The symbols marked on the packing must be adhered to.
3.2 Pre-mounting conditions
The brakes will be supplied completely mounted and with all settings made. The pinion (15) is
supplied as a loose part. If a hand lever is required (4) it is loosely attached and has to be
mounted.
3.3 Sensitivity
Caution!
Make sure to avoid damage as a result of shocks or impacts during transportation. Special care
should be exercised with regard to the radial connecting cable (version without terminal box).
For direct transportation or assembly of the brake, from size 16 there are threaded bores
provided in the coil body (1) for screwing of supporting eyes, see figure 1.
Caution!
The support eye shall not be used for transport and for mounting of the unit motor with mounted
brake.
Make sure to avoid the generation of condensation water as a result of strong temperature
fluctuations.
146
Stromag Dessau
IP 66
5
safety in motion
01.06.2009