Installing The Harness - Air Lift WirelessONE 25870 Installation Manual

WirelessONE

INSTALLING THE HARNESS

1 .
2.Connect compressor to harness.
3. Connect the AL004 circuit to the vehicle ignition.
MN-751
fi g. 6
Connect electrical connector to manifold (B).
a. Push down till fully seated.
b. Push red secondary lock down.
a . Cut off terminal on compressor red wire .
b. Strip ¼" insulation off compressor red wire.
c. Crimp on weather proof blue butt splice (L) to compressor red wire.
d. Crimp on weather proof blue butt splice (L) to harness wire pink wire AL007 (PK-
14GA).
e . Heat buttsplice to seal connection .
f . Connect compressor ground wire ring terminal, harness ground wire ring terminal,
and relay to vehicle ground (fi g. 3).
•
Using one of the self tapping screws for the compressor you can attach
all the components to the vehicle frame ground .
a. Route the AL004 (PK-10GA) wire to a 15A ignition source (G).
•
Cut off the excess wire length if all is not needed .
b. Strip off ¼' insulation off both sides of the inline fuse holder (N) and the AL004 (PK-
10GA) wire.
c. Crimp on the weather proof yellow butt splice (M) to AL004 (PK-10GA) wire.
d. Crimp on the weather proof yellow butt splice (M) to one side of the inline fuse holder
(O).
7