Settings Mode - Air Lift WirelessONE 25870 Installation Manual

WirelessONE
when the battery is getting low .
Settings Mode: Mode in which the user can change the backlighting color, alter the unit
of measure (psig, or BAR).

Settings Mode

1 .
2.
3.
4 .
5 .
Normal Mode
Increasing desired pressure:
Decreasing desired pressure:
MN-751
Press and hold the Up and Down buttons for 5 seconds to enter the settings mode.
Once in the settings mode the display will display "SE" to indicate settings mode.
In the settings mode the M1 button (fig. 8) will scroll through all the backlighting
options .
The M2 button (fig. 8) will toggle between the unit of measure for the pressure and
display "PS" for psig and "BA" for BAR.
Pressing the UP and Down buttons together will exit back into the Normal Mode.
Internal Clips
M1
1 . Initial press of any button will wake up display and not perform any function .
2. Upon wake up the LCD will display the Desired pressure.
3. Pressing the up arrow will increment the desired pressure by 1 psig, or 0.1BAR
depending on the unit of measure selected .
•
When the user releases the button the new desired pressure will be
transmitted to the receiver .
4. Holding the up arrow will increment the desired pressure in units of 5psig or 0.5BAR
depending on the unit of measure selected .
•
When the user releases the button the new desired pressure will be
transmitted to the receiver .
5. The Maximum pressure will be 120psig or 8.3 BAR.
•
If desired pressure is max pressure then pressing the Up arrow will result
in no function .
1 . Initial press of any button will wake up display and not perform any function .
2. Upon wake up the LCD will display the Desired pressure.
M2
Internal Clips
fig. 8
9