Saving And Recalling Memory 1; Saving And Recalling Memory 2; Saving And Recalling Memory 3 - Air Lift WirelessONE 25870 Installation Manual

Saving and Recalling Memory 1:

Saving and Recalling Memory 2:

Saving and Recalling Memory 3:

10
3. Pressing the down arrow will decrease the desired pressure by 1 psig, or 0.1BAR
depending on the unit of measure selected .
•
When the user releases the button the new desired pressure will be
transmitted to the receiver .
4. Holding the down arrow will decrease the desired pressure in units of 5psig or 0.5BAR
depending on the unit of measure selected .
•
When the user releases the button the new desired pressure will be
transmitted to the receiver .
5. The Minimum pressure will be 0psig or 0 BAR.
• If desired pressure is min pressure then pressing the Down arrow will result
in no function .
Recalling Memory
•
Initial press of any button will wake up display and not perform any function .
• Upon wake up the LCD will display the Desired pressure.
• Press the M1 button to set the M1 pressure as the desired pressure.
• Upon the press of the M1 button the display will display "M1".
•
Once the button is released the display will display the new desired pressure and
transmit the desired pressure to the receiver .
Saving to Memory
• With the desired pressure on the LCD Press and hold the memory button for 5
seconds to set the desired pressure to memory 1 .
• While the M1 button is pressed the display will display "M1".
• Once the desired pressure is saved to M1 the display will flash the backlight three
times .
Recalling Memory
•
Initial press of any button will wake up display and not perform any function .
• Upon wake up the LCD will display the Desired pressure.
• Press the M2 button to set the M2 pressure as the desired pressure.
• Upon the press of the M2 button the display will display "M2".
•
Once the button is released the display will display the new desired pressure and
transmit the desired pressure to the receiver .
Saving to Memory
• Press and hold the memory button for 5 seconds to set the desired pressure to
memory 2.
• While the M2 button is pressed the display will display "M2".
• Once the desired pressure is saved to M2 the display will flash the backlight three
times .
Recalling Memory
•
Initial press of any button will wake up display and not perform any function .
• Upon wake up the LCD will display the Desired pressure.
• Press the M1 & M2 buttons to set the M3 pressure as the desired pressure.
WirelessONE
MN-751