Attaching The Air Lines; Checking The System; Operational Modes; Normal Mode - Air Lift WirelessONE 25870 Installation Manual

ATTACHING THE AIR LINES

Manifold to Compressor:
Manifold to "T-Fitting":
"T-Fitting" to Springs:

CHECkING THE SySTEM

1. Pressurize the system to check for leaks.
2. Inspect all air line connections with a solution of 1/5 dish soap to 4/5 water. If a leak is
3. If the compressor or the solenoid fails to function, check the 15 AMP fuse and ground

OPERATIONAL MODES

Normal Mode : Mode in which the user can increment and decrement the desired pressure,
as well as set and recall the three memory pressures. "LB" will be displayed on startup
8
•
Heat buttsplice to seal connection .
e. Select the appropriate type of fuse tap in terminal for your application (fig. 7).
Adapter #1
Adapter #2 *
* Uses 3/16 (smaller) Female Push On Connector
f . Crimp on the correct terminal that mates with the appropriate type of fuse tap in
terminal for your application .
g. Connect the terminal to the inline fuse holder (N).
h. Install fuse (G).
1. Cut a section of the ¼" DOT air line (D) provided to go from manifold to
compressor .
2. Press air line (D) over barb fitting of compressor (C).
3. Insert into "C" port of manifold (B).
1. Cut a section of the ¼" DOT air line (D) provided to go from manifold (B) to "T- Fitting" (F).
2. Press air line (D) into the "1" fitting of manifold (B).
3. Press other side of air line (D) into "T" fitting (F).
1. Cut a section of the ¼" DOT air line (D) provided to go from "T-Fitting" (F) to Left and
Right Air Springs.
2. Insert one side of air line (D) into "T-Fitting" (F) and the other into the Air Springs.
detected in a push-lock-fitting, cut the hose end square and reinstall the air line to the
fitting. Make sure the air line is cut off squarely and that the air line is completely pushed
into the fitting.
connection . Repair and replace as necessary .
WirelessONE
Adapter
Fuse
fig. 7
MN-751