How To Sync The Receiver To The Transmitter; How To Remove And Install The Batteries; Fcc Information To User - Air Lift WirelessONE 25870 Installation Manual

WirelessONE

HOW TO SyNC THE RECEIVER TO THE TRANSMITTER

(ONLy NEEDED WITH A REPLACEMENT TRANSMITTER)
1 .
2.
3.
4 .
5 .
6 .
7 .

HOW TO REMOVE AND INSTALL THE BATTERIES

1.
2.
3.

FCC INFORMATION TO USER

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT
TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAy NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANy INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAy CAUSE UNDESIRED OPERATION.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANy RADIO OR TV
INTERFERENCE CAUSED By UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.
SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITy TO OPERATE THIS
EQUIPMENT.
FCC ID: YHT-BRM920AJM1017
MN-751
• Upon the press of the M1 & M2 buttons the display will display "M3".
•
Once the buttons are released the display will display the new desired pressure
Saving to Memory
• Press and hold M1 & M2 buttons for 5 seconds to set the desired pressure to
memory 3.
• While the M1 & M2 buttons is pressed the display will display "M3".
• Once the desired pressure is saved to M3 the display will flash the backlight three
times .
Turn ignition on .
Locate the sync wire in the wire harness.
•
It will be the yellow wire that is looped with heat shrink around it .
Strip ¼" of the insulation off the end of the wire.
Touch this wire to the self tapping screw that you have used for grounding your receiver
/ compressor .
Disconnect power to the receiver.
•
Unplug the connector on the top .
Connect power to the receiver while grounding the sync input .
Listen for 3 clicks of the internal solenoid, then one click every second.
• This will indicate that you are now in the "sync mode".
• Sync mode will last for 30 seconds total.
• Within the 30 seconds press any button on the transmitter to send a message to
the receiver .
•
Once the receiver has received a message it will sync with that transmitter and stop
clicking the solenoid in 1 second intervals .
To remove the two CR2032 batteries use a small flat screw driver to seperate the two
halves of the key fob by prying at the internal clip locations shown in fig. 8.
Stack the two CR2032 batteries Positive to Negative inside the rear cover.
Clip the front cover and circuit board into the rear cover.
11