Rf Exposure Warning; Figure 3-7 Protective Earthing Conductor - ADRF FiRe-78-4 Installation And Operating Manual

Figure 3-7 Protective Earthing Conductor
Ground terminals located on the side consisted of a 16mm²(6AWG) and should be permanently connected to
earth(Protective earthing conductor).

4. RF EXPOSURE WARNING

In order to comply with the FCC RF exposure requirements, the antenna installation must comply with the following:
The outdoor antenna (Yagi type or similar directional antenna if off air donor signal used) must be installed so as to
provide a minimum separation distance of 0.3 meters (60 cm) between the antenna and persons within the area.
(This assumes a typical antenna with gain of [10.1 dBi, VSWR ≤ 1.5:1, Zo= 50 ohms, and a cable attenuation between
1-10 dB).
The indoor antenna (Omni directional or leaky cable) must be installed so as to provide a minimum separation
distance of at least 8 inches (20 cm) between the indoor antenna connected to the RF booster and the human user's
Advanced RF Technologies, Inc. 16