The SNMP section allows you to specify the Site ID and Description. The Site-ID is the code that is used to
identify the repeater.
8.4.5
Location
This section allows the user to input the latitude and the longitude of the repeater.
8.4.6
Modem Box Setting
This section allows the user to specify alternative Repeater IP, Subnet Mask, and Gateway settings. These
settings are enabled when the Host/Remote switch is set to the Remote position.
8.4.7
AAI Input
The PSR-VU-9537 can accept a dry contact input alarms. The alarm can be labeled in this section. Once the
alarm is labeled, it will show up in the system with the new custom names on the Status tab.
Advanced RF Technologies, Inc.
•
Figure 5-15 SNMP
•
Figure 5-16 Location Setting
•
Figure 5-17 Modem Box Setting
•
Figure 5-18 AAI Input
30