Restore Factory Default Settings; Using The Reset Button; Using The Ivr Command; Table 12: Mac Address Key Mapping - Grandstream Networks HT701 User Manual

RESTORE FACTORY DEFAULT SETTINGS

WARNING! Restoring the Factory Default Setting will DELETE all configuration information of the phone.
Please BACKUP or PRINT out all the settings before you approach to following steps. Grandstream will not
take any responsibility if you lose all the parameters of setting and cannot connect to your VoIP service
provider.

Using the Reset Button

To reset default factory settings using the reset button please follow the steps above:
1. Unplug the Ethernet cable.
2. Locate the reset hole on the back panel of your HT70X .
3. Insert a pin in this hole, and press for about 7 seconds.
4. Take out the pin. All unit settings are restored to factory settings.

Using the IVR Command

Reset default factory settings using the IVR prompt:
1. Dial "***" for voice prompt.
2. Enter "99" and wait for "reset" voice prompt.
3. Enter the encoded MAC address (Look below on how to encode MAC address).
4. Wait 15 seconds and device will automatically reboot and restore factory settings.
Encode the MAC Address
1. Locate the MAC address of the device. It is the 12-digit HEX number on the bottom of the unit.
2. Key in the MAC address. Use the following mapping:
Key Mapping
0-9 0-9
22 (press the "2" key twice, "A" will show on the LCD)
A
222
B
2222
C
33 (press the "3" key twice, "D" will show on the LCD)
D

Table 12: MAC Address Key Mapping

HT70X User manual
Version 1.0.9.4
P a g e | 64