Grandstream Networks HT702 Setup And Troubleshooting Manual

Grandstream Networks HT702 Setup And Troubleshooting Manual

Analog telephone adapter (ata)
Hide thumbs Also See for HT702:

Advertisement

Phone.com Setup and Troubleshooting Guide
Grandstream HT702 Analog Telephone Adapter (ATA)
Setup and Troubleshooting Guide
Grandstream HT702
Analog Telephone Adapter (ATA)
1 / 7
Revised: 30 October 2012

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HT702 and is the answer not in the manual?

Questions and answers

Summary of Contents for Grandstream Networks HT702

  • Page 1 Phone.com Setup and Troubleshooting Guide Grandstream HT702 Analog Telephone Adapter (ATA) Setup and Troubleshooting Guide Grandstream HT702 Analog Telephone Adapter (ATA) 1 / 7 Revised: 30 October 2012...
  • Page 2: Package Contents

    Manual. Expect to spend about 15 to 20 minutes getting your HT702 set up and ready to use. Once it is set up, your phone will work in nearly the same way as your typical home phone. Some familiarity with networking may be required, particularly if you have to change the configuration or any network settings.
  • Page 3: Device Setup

    Grandstream HT702 Analog Telephone Adapter (ATA) Device Setup 1. Using the Ethernet cable that came with your HT702, connect the LAN port of your ATA to an available LAN port on your router. 2. Using a standard RJ11 telephone cable, plug your touch-tone analog phone into the PHONE1 port of the HT702.
  • Page 4 Phone.com Setup and Troubleshooting Guide Grandstream HT702 Analog Telephone Adapter (ATA) Transfer You can transfer incoming calls to other numbers or extensions, although you cannot transfer outbound calls. For example, if you receive a call on your Phone.com extension, but you want another party to continue the conversation, take advantage of this option.
  • Page 5 Phone.com Setup and Troubleshooting Guide Grandstream HT702 Analog Telephone Adapter (ATA) Call Blocking (cont.) If you blocked a number by mistake: ● Dial [*][9] again if you are still on the call. You will hear: “This caller has been unblocked.”...
  • Page 6: Troubleshooting

    2. Make sure your phone is plugged into the correct phone port on the back panel of the HT702. For example, if the LED for PHONE1 is lit, make sure the phone cord is plugged into the PHONE1 port.
  • Page 7: Additional Support

    Contact your internet service provider if you need specific guidance. Additional Support In the end, this guide should help you get your Grandstream HT702 ATA up and running with your Phone.com service, and help you use some of its basic features.

Table of Contents