Grandstream Networks HT701 User Manual page 22

Firmware Server IP
13
Address
Configuration Server IP
14
Address
15 Upgrade Protocol
16 Firmware Version
17 Firmware Upgrade
47 "Direct IP Calling"
86 Voice Mail
99 "RESET"
"Invalid Entry"
"Device not registered"
Notes:
▪ "*" shifts down to the next menu option and "#" returns to the main menu.
▪ "9" functions as the ENTER key in many cases to confirm or toggle an option.
All entered digit sequences have known lengths - 2 digits for menu option and 12 digits for IP
▪
address. For IP address, add 0 before the digits if the digits are less than 3 (i.e. - 192.168.0.26
should be key in like 192168000026. No decimal is needed).
▪ Key entry cannot be deleted but the phone may prompt error once it is detected.
Announces current Firmware Server IP address.
Enter 12 digit new IP address.
Announces current Config Server Path IP address.
Enter 12 digit new IP address.
Upgrade protocol for firmware and configuration
update. Press "9" to toggle between TFTP / HTTP /
HTTPS
Firmware version information.
Firmware upgrade mode. Press "9" to toggle among
the following three options:
•
always check
•
check when pre/suffix changes
•
never upgrade
Enter the target IP address to make a direct IP call,
after dial tone. (See "Make a Direct IP Call".)
Access to your voice mails messages.
Press "9" to reboot the device
Enter MAC address to restore factory default setting
(See Restore Factory Default Setting section)
Automatically returns to main menu
This prompt will be played immediately after off hook
If the device is not register and the option "Outgoing
Call without Registration" is in NO
HT70X User manual
Version 1.0.9.4
P a g e | 21