Fluke CableAnalyzer DSX-602 User Manual page 15

To prevent damage to the tester or cables under
test, to prevent data loss, and to make sure your
test results are as accurate as possible:
Do not connect the tester to an active network.

Doing so causes unreliable test results, can disrupt
network operations, and can cause damage to the
tester.
 Connect only RJ45 plugs to the adapters. Other
types of plugs, such as RJ11 (telephone) plugs, can
cause permanent damage to the jacks.
To make sure your test results are as accurate as

possible, do the reference procedure every 30 days.
See "Set the Reference" on page 29.
Do not operate portable transmitting devices, such

as walkie-talkies and cell phones, during a cable
test. Doing so can cause errors in test results.
For permanent link adapters, do not twist, pull on,

pinch, crush, or make kinks in the cables. See Figure
4 on page 13.
Do not remove the USB flash drive while the LED on

the drive flashes. Doing so can corrupt the data on
the drive.
You can lose a USB flash drive, cause damage to it,

or accidentally erase the contents of the drive. Thus,
Fluke Networks recommends that you save no more
than one day of test results on a flash drive, or that
you upload results to LinkWare Live. See Chapter 4.
W
Caution
Chapter 1: Get Acquainted
WSafety Information
7