Factory Settings; Power Actuator - Emerson EIM TEC2 500 Quick Start Manual

Welcome to TEC2 Quick-Start Guide
E2K-210-05-18 Rev. 3
September 2018

Factory Settings

The actuator has been configured as specified in the order. No further changes should be necessary other than
setting the position limits, and, if network controlled, setting a unique network address. If full data was not
provided when ordering or if changes are needed, see the TEC2 Installation & Operation Manual
(E2K-420-0117), which can be found at www.emerson/eim.

Power Actuator

Verify the voltage rating on the unit nameplate. Connect power to the unit.
Are Position Limits Set?
Does "SET LIMITS BEFORE OPERATING," "EE%," and the alarm icon appear, and is the yellow LED
blinking? If so, then position limits have not been set.
2 Welcome to TEC2