Emerson EIM TEC2 500 Quick Start Manual page 5

Quick-Start Guide
E2K-210-05-18 Rev. 3
Setting Valve Position Limits
1 2
STOP
YES,
NO,
YES,
NO
Release
quickly.
Place the selector knob in the STOP position. Then toggle the control knob in rapid succession to YES, then
NO, then YES, then NO and release. The Setup icon will be displayed on the display module and "SETUP?" will
be displayed on the message center. Rotate the control knob to "YES." The message center will display "SET
LIMITS BEFORE OPERATING." Set position limits as described on the next pages.
Setting Valve Position Limits Initially
Setting Valve Position Limits Initially
Initially
3
YES
September 2018
4
LOCAL
3