Quick-Start Guide
E2K-210-05-18 Rev. 3
Network
Controlled
(CAM and Controlinc
1
REMOTE
In the "SETUP" mode advance to "NETWORK SETUP?" using the selector knob in the REMOTE position.
Answer YES. Hold the control knob in the NO position until the correct address appears. Answer YES. Unit
is now network controlled. If other configuration changes are needed, please see the TEC2 Installation &
Operation Manual (E2K-420-0117), which can be found at www.emerson/eim.
Network Controlled
option required)
®
2
NO
Until...
3
YES
Network Controlled
September 2018
4
NO
YES
Until
correct
address...
5
13