Stratasys Dimension BST 1200 User Manual page 25

6. Use the three functions above to set your IP address.
7. After setting the final digit of the IP address, move the cursor
one more place to the right. The cursor moves to the NM (or
Netmask) address. Follow the same steps for setting the NM
and GW addresses.
8. When you have finished setting the addresses, press Done.
The panel displays Change IP, Netmask, Gateway?
9. Press Yes. The panel then displays Resetting Network
and after a moment returns to Idle or starts warming up.
10. If you have not done so already, plug in the network patch
cable from your network to the rear of Dimension.
11. From your PC, start the CatalystEX application.
Detailed instructions for using CatalystEX can be found in the
CatalystEX Help file.
A. From the General Tab, click the 'Manage 3D Printers'
button.
B. Click the 'Add from Network...' button in the lower right
corner of the pop-up.
C. A new pop-up, 'Add 3D Printer', should list your printer in
the main window (identified by its UDN). Click on the
printer in this window and enter a Name and Location (your
choice) in the lower portion of the pop-up.
D. Click 'Add Printer' - and you are ready to go. Close the 3D
Printer pop-up.
12. If your printer is NOT displayed in the 'Add 3D Printer' pop-up
(Step 11.C.), you will need to add the printer IP address
manually.
A. From the General Tab, click the 'Manage 3D Printers'
button.
B. Click the 'Add Manually...' button in the lower right corner
of the pop-up.
C. In the pop-up, 'Add 3D Printer', enter a Name and Location
(your choice) for your printer in the appropriate fields.
NOTE
Dimension BST 1200 / SST 1200 User Guide
Setup 25