Stratasys Dimension BST 1200 User Manual page 66

66 Troubleshooting
6. Snip the filament line from the cartridge close to the drive
wheel.
7. Make sure that all loose filament is removed from the affected
liquefier inlet area.
8. Check for loose material in the other liquefier inlet area. Clean
the area as necessary.
9. Install plastic head cover.
10. Exit Maintenance - press Next > then Done.
11. Unload the material. Make sure that the cartridges are entirely
removed so that all of the filament loaded into the printer can
be withdrawn. (See
It is recommended that an unload be performed for each
material.
12. Load material (See
Dimension BST 1200 / SST 1200 User Guide
"Unloading Material" on page
NOTE
"Loading Material" on page 32
35.