10. Next you are prompted with Load Support - Ready to
Load Support Material (if not previously loaded). Press
Load to load support material.
•
Watch the support extrusion tip (see
material extrudes (purges) after loading. The panel will
then display Did Support Material Purge?
•
Press Yes (to return the printer to the Ready to Build
state) or No (to return to Load Material) as appropriate —
or press Purge Again if you're unsure which to choose.
If the display shows
again, remove the cartridge, snip the material (see
on
page
34), remove filament in the printer, and reinsert the
cartridge.
Unloading Material
The model and support material cartridges may be replaced
separately or at the same time. In idle-, load-, or build-related
modes, the panel displays the percentage of material remaining in
the cartridges. If the printer will be operating unattended for a long
period, and the material level is getting low, you may want to
replace the cartridges before starting a new part. Of course, you
will also need to replace the cartridges when they are empty.
Figure 12: Close-up of extrusion tips
NOTE
Load Failed
Dimension BST 1200 / SST 1200 User Guide
Operation 35
Figure
12) to see if
, press
Retry
. If load fails
Figure 11