Tip Area Clean-Up - Stratasys Dimension BST 1200 User Manual

4. Remove the light bar by removing the 3 attachment screws
(top, middle, bottom) - use the 1/8 T-handle wrench supplied in
the Startup Kit.
5. Install a replacement light bar with the 3 attachment screws -
do not overtighten the screws.
6. Re-attach the wiring harness lead.

Tip Area Clean-up

Material can build up on the metal strip behind the extrusion tips
(Figure 19). Build up can be caused by an overflowing Purge
Bucket or an improperly adjusted Tip Cleaning Assembly.
1. Enter Head Maintenance (tips must be hot to clean area).
A. From Idle, press Maintenance.
B. Press Next. The head will come to rest in the center of the
chamber and the Z Platform will change position. Choose
Head Maintenance.
2. Clean the area of all material using the needle nose pliers
supplied with your Start Up Kit.
3. Exit Maintenance.
Build Up Area
The head area is very hot!! Use leather
gloves when working in this area of
printer!
Figure 19: Material Buildup Behind Tips
Dimension BST 1200 / SST 1200 User Guide
WARNING
Maintenance 51