Stratasys Dimension BST 1200 User Manual page 24

24 Setup
B. Click the 'Add from Network...' button in the lower right
corner of the pop-up.
C. A new pop-up, 'Add 3D Printer', should list your printer in
the main window (identified by its UDN). Click on the
printer in this window and enter a Name and Location (your
choice) in the lower portion of the pop-up.
D. Click 'Add Printer' - and you are ready to go. Close the 3D
Printer pop-up.
If your printer is not displayed in the 'Add 3D Printer' pop-up,
you are not using a Dynamic network. You will need to set up
a Static Network address.
If necessary, set the Static Network addresses:
1. Obtain your network addresses from your Network
Administrator.
2. From Idle (or Ready to Build), press Maintenance.
The panel displays System Maintenance and the software
version.
3. Press Set Network. The top window displays: Network
Admin - Static IP Address; UDN
4. Press Static IP to display current settings. For example::
IP Address: 192.000.000.001
NM Address: 255.255.000.000
GW Address: 198.000.000.001
These are the factory default addresses; they must be
changed for your network.
5. Look for the cursor beneath the first digit of the IP address. The
cursor does not blink. To update the IP address:
Press Increment to increase the value one digit at a time.
Press Next Digit to move the cursor one place to the
right.
Press Last Digit to move the cursor one place to the
left.
Dimension BST 1200 / SST 1200 User Guide
NOTE