Protective Cover Installation - Allen-Bradley A Series Installation Instructions Manual

10 Universal Disconnect Switch Installation Instructions (200A)

Protective Cover Installation

1
Position cover in front of switch as shown. Remove line side
shield.
3
Rotate cover up and slide top sides into tracks shown on switch.
Push in until fully inserted and pull cover down slightly to ensure
engagement.
5
Ensure flange on left side of cover has snapped under fuse block.
6
Install screw in bottom slot.
2
Spread sides apart at bottom to fit around fuse block.
4
Press center of cover tight to mounting plate to engage notch in right
side of cover with switch bracket.
Publication 1494U-IN007B-EN-P - July 2018