SC&T 4K HDMI KVM USB/RS232/IR/Analog Audio CAT5e Extender over IP Series User Manual page 4

Panel Button Function:
HKM02B-4K/HKM02BP-4K
Button
Short Press
Press together
Press 3 seconds
Press 6 seconds
Press and hold then power on
HKM02B
Button
Short Press
Press 3 seconds
Press 6 seconds
Press and hold then power on
In engineering mode Power and Link LED will be flash together, IP address of unit will be set to Static
IP 192.168.0.88 temporarily, users can login to the web page by browser to change settings or
update firmware.
Rotary Switch Function:
HKM02BT Transmitter built in rotary switch to set channel numbers follow 16 HEX, could switch " 0 ~ F
" total 16 channels, A = channel 10, B = channel 11, others channel same as 16 hex conversion.
For channel numbers over 15 you could use panel button, IR remote, RS-232, APP to set up.
Front Panel LED Indication Status:
Panel LED Status
Flash Twice
Power
Green LED
Flash Slowly
Breathing(Fading) Screen saver mode (not available for transmitter)
Link
Blue LED
Flash
IR
Red LED
Flash
UTP
Green LED
Flash
SFP
Blue LED
Flash
MSG
Red LED
Flash
-
Reduce Value
Enter
Carry
Factory Default
-
Reduce Value
Carry
Factory Default
(HKM02BT only)
On Boot completed
Booting
Transmitter: standby( by IR remote power button only)
Receiver: video output be turned off
On Connected
Connecting, or no source input from transmitter
On Transmitting /receiving IR signal
On Connected by UTP RJ45 port
Transmitting /receiving data from
UTP RJ45 port
On Connected by Fiber SFP port
Transmitting /receiving data from
Fiber SFP port
Other message (IR, RS232,
On
System setting...)
System warring, Alert
+
Increase Value
Decomposition
Lock/Unlock Button(When no OSD menu)
Engineering Mode Set Factory Default then enter Engineering Mode
+
Increase Value
Decomposition
Lock/Unlock Button(When no OSD menu)
Engineering Mode Set Factory Default then enter Engineering Mode
HKM02B-4K
& video is streaming
Menu
Menu/Cancel
- and + together
Enter
Menu/Cancel
HKM02B
System warring, Alert