Problems And Solutions - Sharp AR-M355N Operation Manual

PROBLEMS AND SOLUTIONS

If you experience a problem with the fax function, first check the following table. If you cannot solve the problem using
the following table, see chapter 6 of the Operation Manual (for general information and copier operation).
Problem
The machine does Is the fax power switch turned on? Turn on the fax power
not operate.
Is the correct dial mode set for
your line?
Is the telephone line properly
connected?
Dialing is not
Is the machine power switch
possible.
turned on?
Is the machine in fax mode?
Does the receiving fax machine
have paper?
Does
support G3 transmission?
The receiving Are
machine does not passcode correct?
receive your fax.
Is the receiving machine ready to
receive?
Was the original size detected
correctly?
Was the original placed so that the
correct side is scanned?
The transmitted
image prints out
If the receiving machine is using
blank at the receiving
thermal paper, was the thermal
side.
paper loaded with the wrong side
out?
Were line conditions poor due to
thunder or another reason?
Were the resolution and exposure
The transmitted
settings suitable?
image is distorted.
Transmission does Is the machine's clock set to the
not take place at the correct time?
specified time.
7-4
Check
the receiving machine
the sub-address and
Solution
switch.
Check your line and set the
correct dial mode.
Check the connections.
Turn the machine power
switch on.
Press the [IMAGE SEND]
key to set the machine to
fax mode.
Check with the operator of
the receiving machine.
Check the transmittable
sizes.
Make sure the original is
placed so that the correct
side is scanned.
Check with the operator of
the other machine.
Try the transmission again.
Check the resolution and
exposure settings.
Set the clock to the correct
time.
Page
"Fax power switch",
page 0-4.
"Dial mode setting
(Setting your line type)",
page 8-5.
"Line connection", page
0-4.
Operation manual (for
general information and
copier operation), page
1-17.
"BASIC PROCEDURE
FOR SENDING
FAXES", page 2-2.
_
"CHECKING THE SIZE
OF A LOADED
ORIGINAL", page 1-8.
"LOADING A
DOCUMENT", page 1-7.
_
_
"SELECTING
RESOLUTION AND
EXPOSURE
SETTINGS", pages 1-10
and 1-11.
Operation manual (for
general information and
copier operation), page
2-12.