G Setting For F-Code Relay Broadcast Memory Boxes (Recipient); Setting For F-Code Relay Broadcast Memory Boxes; Recipient - Sharp AR-M355N Operation Manual

SETTING FOR F-CODE RELAY BROADCAST MEMORY
BOXES (RECIPIENT)
Program the end receiving machines to which document data received in the F-code relay broadcast memory box
will be transmitted when your machine is a relay machine.
Up to 30 end receiving machines can be programmed. If you attempt to program more than this number, a message
will appear and programming will not be possible.
1 Touch the [RELAY BROADCAST] key in
step 3 of "PROGRAMMING AN F-CODE
MEMORY BOX" on pages 6-10 to 6-11 and
store a box name, sub-address, and
passcode.
Touch the [RECIPIENT] key.
2
FAX INFORMATION
BOX NAME
SUB ADDRESS
123456/987654

RECIPIENT

3 Touch the one-touch keys you wish to
include as end receiving machines.
Touch indexes and the
needed.
F-CODE MEMORY BOX / RELAY BROADCAST
SELECT ADDRESS.
B
A
C GROUP CLIFF QUIROGA
DANIEL ERNY
FREQUENT USE ABCD EFGHI JKLMN
G The selected one-touch keys are highlighted and
programmed as end receiving machines.
G If you touch an incorrect key, touch the key again to
remove the highlighting and delete the destination.
G You can also use the [
to store a one-touch key. (See "SENDING A FAX
BY SPEED DIALING" on page 2-4.)
G To enter a fax number that has not been stored in
a one-touch key, to enter a full fax number with the
numeric keys, touch the [DIRECT ENTRY] key and
then the [FAX] key and enter the fax number.
OK
FAX
E-MAIL DIRECT ENTRY
ADDRESS REVIEW
INTERNET-FAX
UVWXYZ
JKLMN OPQRST
ABC GROUP
G Enter the fax number and then a sub-address and
transmission settings (if desired) as explained in
steps 10 to 13 and 15 of "STORING ONE-TOUCH
DIAL KEYS" on pages 6-3 to 6-4, and then touch
the [OK] key twice to return to the screen of step 3.
PROGRAMMING, EDITING, AND DELETING F-CODE MEMORY BOXES
The address selection
screen appears.
keys as
OK
1/1
DIRECT ENTRY
ADDRESS REVIEW
* 2
OPQRST UVWXYZ
ABC GROUP
] key (speed dial key)
4 To check the destinations that have been
selected as end receiving machines,
touch the [ADDRESS REVIEW] key.
OK
1/2
DIRECT ENTRY
ADDRESS REVIEW
* 0
OPQRST UVWXYZ
GROUP
ABC
confirmation message appears, touch the [YES]
key to delete the destination.
5 Touch the [OK] key in the screen of step 3.
You will return to the screen of step 2 and the
number of stored as end receiving machines will
appear.
To exit, touch the [EXIT] key. To program
6
another memory box, touch the [NEXT] key.
Touching the [EXIT] key returns you to the screen
of step 3 on page 6-10.
Touching the [NEXT] key returns you to the screen
for programming a new memory box (the screen of
step 4 on page 6-10).
The destinations
selected as end
receiving machines are
displayed.
You can delete a
destination by touching
it. When the
6-13
6