Demounting Periphery Modules - YASKAWA VIPA IM 053EC Manual

Basics and mounting
Demounting > Demounting periphery modules

2.6.2 Demounting periphery modules

Proceeding
Exchange of an electronic
module
Exchange of a periphery
module
28
9. Plug again the electronic module, which you have removed before.
10. Wire your bus coupler.
ð Now you can bring your system back into operation.
1. Power-off your system.
2. For the exchange of a electronic module, the electronic module may be pulled for-
ward after pressing the unlocking lever at the lower side of the module.
3. For installation plug the new electronic module guided by the strips at the lower side
until this engages to the terminal module.
ð Now you can bring your system back into operation.
1. Power-off your system.
2. Remove if exists the wiring of the module.
3.
For demounting and exchange of a (head) module or a group of
modules, due to mounting reasons you always have to remove the
electronic module right beside. After mounting it may be plugged
again.
Press the unlocking lever at the lower side of the just mounted right module and pull
it forward.
VIPA System SLIO
HB300 | IM | 053-1EC01 | en | 18-49