Hotconnect Via Configured Station Alias - YASKAWA VIPA IM 053EC Manual

VIPA System SLIO

4.2.2 HotConnect via Configured Station Alias

Proceeding
HB300 | IM | 053-1EC01 | en | 18-49
Setting the HotConnect address > HotConnect via Configured Station Alias
The specification of the HotConnect address via Configured Station Alias happens as fol-
lows:
1. In your configuration tool, connect to the corresponding slave station. This must be
in the INIT state.
2. Adjust the Configured Station Alias in the SII (EEPROM).
3. Perform a power cycle.
ð The value set in the SII is used as Configured Station Alias.
Information on how to enter an ESC register and a Configured Station
Alias address in your configuration tool can be found in the associated
manual.
For example, in the EtherCAT Manager you must open the 'Advanced
options' of the slave station in your configuration, activate 'Check
identification' and enter the ESC register address 0x0012 at 'Select local
address' . In this case, the Configured Station Alias address must be
specified in 'Diagnostics mode' via 'EEPROM' and in 'Group' via
'Identification value' .
Deployment
49