Figure A-17. Remote Switch Cast Box - Comtech EF Data XSAT-7080 Series Installation And Operation Manual

XSAT7080 X-Band Transceiver
5-25W Installation
A.5.3 C C
ONNECT
AS/0440 C
Note: Refer to Figure A-18a for assembled view, refer to Figure A-21for LNA port
locations, and refer to Figure A-12 for Cable kit.
Step
1
2
3
4
5

Figure A-17. Remote Switch Cast Box

R
ABLING TO THE EMOTE
K
ABLE IT
Procedure
Connect one end of the Control cable, (4, Figure A-12) to UNIT A
(1, Figure A-17) connector.
Connect one end of the Control cable, (5) to UNIT B (2, Figure A-17)
connector.
Connect one end of Cable (2) to RX SWITCH (3 , Figure A-17) connector.
Connect one end of Cable (3, figure A-13) to TX SWITCH connector (4 ,
Figure A-17). Set box aside for later installation.
The four RF cables, (1, Figure A-12) are used to connect the IF ports on the
switch controller to the units.
S B , AS/0490
WITCH OX
Figure A-18a. Switch Box with Cables
A–19
Revision 0
MN/XSAT7080.IOM
USING