XSAT7080 X-Band Transceiver
50 and 100-Watt Installation
B.4.3 LNA I
NSTALLATION
The LNA is mounted to the OMT using Waveguide Kit, CPR112, PN AS/9751-1
To install a single LNA to an antenna, proceed as follows:
Step
1
2
3
Procedures
Remove the protective cover from the antenna OMT and LNA.
Install the appropriate gasket on the antenna end of the LNA.
If only one of the mounting surfaces has a groove, use the half-thick gasket.
a. If both mounting surfaces have grooves, use the full thick gasket.
b. Position the LNA (with gasket) in place on the antenna and fasten using the
supplied hardware.
Figure B-8. Installation of LNA
B–9
Revision 0
MN/XSAT7080.IOM