Comtech EF Data XSAT-7080 Series Installation And Operation Manual page 87

XSAT7080 X-Band Transceiver
5-25W Installation
Step Procedure
10 Place bracket (1, Figure A-2) over springnuts and secure using screws (3).
Observe the orientation of the "Key" slots used for mounting the XSAT
Transceiver.
IMPORTANT
11 Mount the unit as follows:
a.
b.
Loosely install four bolts (4 Figure A-2), four flat washers (4), and four
split washers (6) into bolts hole located on the rear side of the unit.
Position unit against the bracket and hook the bolts into the key slots.
Tighten bolts to secure.
Figure A-5. XSAT Single-Thread
Bracket with Hardware
Figure A-6. Installing XSAT Single-
Thread Bracket
A–7
Revision 0
MN/XSAT7080.IOM