XSAT7080 X-Band Transceiver
50 and 100-Watt Installation
B.7 LNA A
SSEMBLY
Install assembled Redundant LNA assembly as follows:
Step
Procedures
1
Remove the protective cover from the antenna OMT.
2
Install the appropriate gasket (2, Figure B-13 or Figure B-14) on the antenna end
of the TRF.
3
Install the appropriate gasket (2, Figure B-13 or Figure B-14) on the antenna end
of the TRF.
a. If only one of the mounting surfaces has a groove, use the half-thick
b. If both mounting surfaces have grooves, use the full thick gasket (5).
4
Position the LNA switch assembly (with gasket) in place on the antenna and fasten
using the supplied hardware.
gasket.(2).
B–27
Revision 0
MN/XSAT7080.IOM