Table of Contents
Advertisement
5.6.
Saw chain lubrication
The saw chain is automatically lubricated
whenever it starts to rotate.
pressure feeds oil from the tank to the saw
chain. Use a hexagonal key and the hole in the
frame on the left side of the saw bar to adjust
the amount of oil (see Figure 47a).
Add saw chain oil through filler cap A. Oil level
gauge B indicates the proper time to add oil.
When gauge B is light brown, the oil level is
sufficient, but when the gauge is clear, oil
must be added (see Figure 47).
5.7.
Solenoid and pressure regulating valves
The machine's cartridges have been adjusted to the correct settings at the factory. The firewood
processor's guarantee is void if the factory settings are changed. If you need to change the settings for any
reason, first contact the manufacturer or retailer and follow their instructions carefully. Changing the
cartridge settings incorrectly may damage the machine or render it hazardous to operate. If the relief
valve settings should be changed, do it as follows: loosen the locking nut and tighten or loosen the hex
socket screw as needed (when the screw is tightened, the pressure increases and vice versa). Finally,
tighten the locking nut. The locations of the relief valves are indicated in the following figures.
Hakki Pilke 38 Pro
33 / 40
The pump
Translation
Figure 47.
Figure 47a.
Version 3
Hide quick links:
Advertisement
Table of Contents
