Table of Contents
Advertisement
ME Recovery
ME Recovery (JPME1) is used to en-
able or disable the ME Recovery fea-
ture of the motherboard. This jumper
will reset Intel ME values back to their
default settings.
VRM SMB Clock/Data
The VRM SMB Clock/Data is used to
select where the Voltage Regulator
Module's System Management Bus
clock signal (J29) or data (J30) is
directed to. Select between BMC or
PCH. Note: both jumpers must be set
to the same setting.
BMC Enable/Disable
JPB1 is used to enable or disable
the BMC (Baseboard Management
Control) chip and the onboard IPMI
connection. This jumper is used to-
gether with the IPMI settings in the
BIOS. See the table on the right for
jumper settings.
Chapter 5: Advanced Serverboard Setup
ME Recovery
Jumper Settings
Pin#
Definition
Pins 1-2
Pins 2-3
VRM SMB Clock/Data
Pin Definitions
Pin#
Definition
Pins 1-2
Pins 2-3
BMC IPMI Enable/Disable
Jumper Settings
Settings
Pins 1-2
Pins 2-3
5-23
Normal (Default)
ME Recovery
BMC (Default)
PCH
Definition
Enabled (Default)
Disabled
Advertisement
Table of Contents
