Table of Contents
Advertisement
S
S
UPER
ERVER 1017R-WR User's Manual
LAN Enable/Disable
Change the setting of jumper JPL1 to
enable or disable the onboard Ether-
net (RJ45) ports LAN1 and LAN2. See
the table on the right for jumper set-
tings. The default setting is enabled.
Watch Dog Enable/Disable
JWD controls the Watch Dog function.
Watch Dog is a system monitor that
can reboot the system when a software
application "hangs". Pins 1-2 will cause
WD to reset the system if an applica-
tion hangs. Pins 2-3 will generate a
non-maskable interrupt signal for the
application that has hung. See the table
on the right for jumper settings. Watch
Dog must also be enabled in BIOS.
Note: When enabled, the user needs to
write their own application software to
disable the Watch Dog Timer.
VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position is on
pins 1 and 2 to enable VGA. See the
table on the right for jumper settings.
PCI Slot SMB Enable
Use jumpers JI
SMB (System Management Bus) support
to improve system management for the
PCI slots. See the table on the right for
jumper settings.
C2/JI
C3 to enable PCI
2
2
LAN Enable/Disable
Jumper Setting
Pins 1-2
Pins 2-3
Jumper Setting
Pins 1-2
Pins 2-3
Open
VGA Enable/Disable
Jumper Setting
Pins 1-2
Pins 2-3
PCI Slot SMB Enable
Jumper Settings
Jumper Setting
Short (Default)
Open
5-22
Jumper Settings
Definition
Enabled
Disabled
Watch Dog
Jumper Settings
Definition
Reset
NMI
Disabled
Jumper Settings
Definition
Enabled
Disabled
Definition
Enabled
Disabled
Advertisement
Table of Contents
