Configuration Examples; Example For Configuring Telnet Services - Huawei AR1200 Series User Configuration Manual

Huawei AR1200 Series Enterprise Routers
Configuration Guide - Basic Configuration
Procedure
l
----End
Example
Run the display sftp-client command on the client to view the source parameters of the device
functioning as an SFTP client.
<Huawei> display sftp-client
Info: The source address of SFTP client is 1.1.1.1

8.7 Configuration Examples

This section describes examples for access another device. The examples explain networking
requirements, configuration notes, and configuration roadmap.

8.7.1 Example for Configuring Telnet Services

This example shows how to configure authentication modes and passwords for users to log in
using Telnet.
Networking Requirements
As shown in
B from Router A using Telnet.
Figure 8-5 Networking diagram for configuring user login with Telnet services
RouterA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
Issue 04 (2012-05-15)
Run the display sftp-client command to check the source IP address of the SFTP client on
the SSH client.
Figure 8-5, Router A and Router B can ping each other. A user logs in to Router
Eth1/0/0
1.1.1.1/24
On Router B, configure authentication modes and passwords for VTY0 to VTY4.
Configure passwords for users to log in to Router B from Router A using Telnet.
Configure a Telnet server port number on Router B so that users log in through a single
specific port only.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Eth1/0/0
1.1.1.2/24
RouterB
8 Accessing Another Device
169