Huawei AR1200 Series User Configuration Manual page 212

Huawei AR1200 Series Enterprise Routers
Configuration Guide - Basic Configuration
l
Issue 04 (2012-05-15)
Figure 9-5 Running a TFTP server program on the PC
2. Set Current Directory to the directory of the backup system file by clicking
Browse, and place the system file to the specified directory. Set Server Interface to
the IP address of the TFTP server. The IP address is usually displayed automatically.
3. Run the tftp tftp-server get source-filename [ destination-filename ] command on the
router to download the system file from the PC.
NOTE
Before downloading the system file from the PC, ensure that there is enough space on the
router to store the system file.
4. Run the dir command on the router to check whether the system file exists in the
current directory.
NOTE
If the size of the system file in the current directory on the router is different from that on the
PC, an error may occur during file transfer. Upload the system file again.
Downloading a system file to the AR1200 using the BootROM menurouter
NOTE
This method is not recommended because the upgrade procedure is complicated. Use this method
only when the router system software cannot start.
Connect the router's management interface to the PC.
The management interface varies according to the device model:
l AR150: Ethernet0/0/3
l AR200: Ethernet0/0/6
l AR1200: GigabitEthernet0/0/0
l AR2200: GigabitEthernet0/0/0
l AR2240: GigabitEthernet0/0/2
l AR3200: GigabitEthernet0/0/2
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 Upgrade and Maintenance
200