Displaying System Configuration; Displaying System Status; Collecting System Diagnostic Information - Huawei AR1200 Series User Configuration Manual

Huawei AR1200 Series Enterprise Routers
Configuration Guide - Basic Configuration
Context
You can use display commands to collect information about system status. The display
commands perform the following functions:
l
l
l
See related sections concerning display commands for information on protocols and interfaces.
This section only shows system-level display commands.
Run the following commands in any view.

3.2.1 Displaying System Configuration

This section describes how to use command lines to check the system version, system time,
original configuration, and current configuration.
Procedure
l
l
l
l
----End

3.2.2 Displaying System Status

This section describes how to use command lines to check system operating status (the
configuration of the current view).
Procedure
l
----End

3.2.3 Collecting System Diagnostic Information

This section describes how to collect information about system modules.
Issue 04 (2012-05-15)
Display system configurations.
Display system running status.
Display diagnostic information about a system.
Run the display version command to display the system version.
Run the display clock command to display the system time.
Run the display saved-configuration command to display the original configuration.
Run the display current-configuration command to display the current configuration.
NOTE
l The display version command displays the software version of the system, the chassis type, and
information about the main control board and interface board.
When a user runs the display current-configuration command, other users cannot run the same
command until all the command output is displayed.
l The original configuration refers to information about configuration files used by the device when
it is powered on and initialized. The current configuration refers to the configuration files that
take effect when the device is in use. For details, see the chapter "Configuring System Startup"
in the AR1200 Basic-Configuration.
Run the display this command to display the configuration of the current view.
NOTE
When a user runs the display this command, other users cannot run the same command until all the
command output is displayed.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Basic Configuration
40