Connecting Web Management - Samsung OfficeServ 7030 Installation Manual

3) When the <Link Control> is displayed, enter the name of the system in the [Name]
field.
4) If the Link Type is LAN, enter the IP address of the OfficeServ 7030 system in the
[IP Address] field.
If the Link Type is MODEM, enter the internal modem number of the OfficeServ 7030
system in the [Telephone] field.

6.2.7 Connecting Web Management

The OfficeServ 7030 system is equipped with the Web Management web server, and
supports remote access through the network. The system administrator can change the
system setting by accessing the Web Management screens with an internet browser.
This section describes how to access the OfficeServ 7030 system.
To use within an in-house network, connect LAN to the LAN port of the base board and try
accessing from a client PC.
Setting the Network parameter through MMC830
Set the network parameter of the OfficeServ 7030 system. The required setting for this
address will be determined by the network administrator. (see also section 2.4)
1) Set the IP addresses of the OfficeServ 7030 system. (Master and Slave)
2) Set the subnet mask of the OfficeServ 7030 system.
3) Set the gateway address of the OfficeServ 7030 system.
4) Reset the board.
Resetting the Board
To apply the new setting, the board must be reset.
Default IP Address
The default IP addresses for a new System are as follows
Basic Cabinet:
Expansion Cabinet:
© SAMSUNG Electronics Co., Ltd.
10.0.2.10
10.0.2.12
OfficeServ 7030 Installation Manual
6-11