4) Align the holes of the OfficeServ 7030 cabinet to the bracket screws, and then pull
down the cabinet to secure in place.
3.2 Connecting Basic and Expansion Cabinets
If the OfficeServ 7030 system is a dual cabinet installation, connect the Basic cabinet to the
expansion cabinet using the extension cables to allow signal transmissions between the
base boards.
1) Three extension cables are needed to connect the Basic cabinet to the expansion
cabinet. These are provided as a labeled cable set.
2) With an extension cable, connect the basic cabinet's 'Link1' port to the extension
cabinet's 'Link1' port.
© SAMSUNG Electronics Co., Ltd.
Figure 3.5 Installation on a Wall (4)
Figure 3.6 Extension cable
OfficeServ 7030 Installation Manual
3-3