Gpib-Mac Dip Switch; Factory Use Only - National Instruments GPIB-MAC User Manual

November 1985
Configure the GPIB-MAC Rear Panel Switches
Configure the GPIB-MAC by setting the switches of the g-pin, rear
panel DIP switch. The following figure shows the switches
labeled for factory use only, 7- or g-bit word length, one or two
stop bits, odd/even or no parity, and baud rate.
Switches 1 and 2 - Factorv Use Only
Switch 1 and 2 are for factory use only and should always be
positioned in the off position as shown below.
8 SECTION TWO: INSTALLATION AND CONFIGURATION

GPIB-MAC DIP Switch

Factory Use Only

011 4800
100 9600
101 19.2K
110 38.4K
111 57.6K