Table of Contents
Advertisement
November 1985
Turn Power Switch to On
The power switch is located at the left of the power cord receptacle.
Turn the switch to On. There will be a slight delay while the unit
performs a self-test of all the internal circuitry. The test does not
affect devices connected to the GPIB-MAC. When the test
successfully completes, the BEADY LED comes on. If it does not,
verify your switch settings and the power connections. If the
BEADY LED still fails to come on, contact National Instruments.
Note - The rear panel switches are read by the fiiware only when
the unit is powered on. After changing switch settings, turn the
power switch off and back on for the change to take effect. Also,
the GPIB address of the GPIB-MAC at power on is 0 with
secondary addressing disabled. You can change these values after
power-on using a programming message.
15
SECTION TWO: INSTALLATION AND CONFIGURATION
Advertisement
Table of Contents
