Table of Contents
Advertisement
November 1985
Connect Cables
You must connect three cables to operate the GPIB-MAC: the serial
cable, the power cable, and the GPIB cable. The three cables all
connect to the GPIB-MAC via the rear panel, as shown in the
following figure.
GPIB-MAC with Serial Cable, Power Cable, and GPIB
Cable
The power cord receptacle is located at the top left of the rear panel.
If 115 VAC is required, use the standard power cable supplied with
the unit. If 230 VAC is required, use a cable that is compatible with
both the GPIB-MAC power receptacle and the 230 VAC plug
configuration.
The GPIB cable should be connected to the 24-pin GPIB connector
on the lower right of the rear panel. The connectors can be piggy-
backed to add more GPIB devices to the bus. Connect the serial
cable to the 9-p& D-subminiature connector on the back of the
GPIB-MAC. Connect the other end of the cable to your Macintosh
modem port.
14
SECTION TWO: INSTALLATION AND CONFIGURATION
Advertisement
Table of Contents
