Fuel System Secondary Filter - Replace - Perkins 2206-E13 Operation And Maintenance Manual

74
Maintenance Section

Fuel System Secondary Filter - Replace

Illustration 43
Typical example
Note: The filter element for the primary fuel filter is
different from the filter element for the secondary
fuel filter. Ensure that the correct filter elements are
installed into the filter system.
4. Ensure that the insert (3) is the same shape as
the tab (2).
5. Align the insert to the tab. Install the element into
the filter bowl.
Illustration 44
Typical example
6. Install the new O ring seal (4). Lubricate the
threads on the bowl assembly with CV60889
Special Lubricant.
7. Install the bowl assembly. Tighten the assembly
to a torque of 80 N·m (59 lb ft).
8. Remove the container and dispose of the fuel
safely. Turn the fuel supply valve (if equipped) to
the ON position.
9. Prime the fuel system. Refer to the Operation and
Maintenance Manual, "Fuel System - Prime" for
more information.
10. Operate the engine and check for fuel leaks.
Fuel System Secondary Filter -
Replace
g01394544
Fuel leaked or spilled onto hot surfaces or elec-
trical components can cause a fire. To help pre-
vent possible injury, turn the start switch off when
changing fuel filters or water separator elements.
Clean up fuel spills immediately.
Do not allow dirt to enter the fuel system. Thoroughly
clean the area around a fuel system component that
will be disconnected. Fit a suitable cover over discon-
nected fuel system component.
1. Turn the fuel supply valve (if equipped) to the OFF
position. Place a suitable container under the fuel
filter assembly. Clean the outside of the secondary
fuel filter assembly.
g01394600
SEBU8337
i02793014
NOTICE