Perkins 2206-E13 Operation And Maintenance Manual page 75

SEBU8337
Illustration 45
Typical example
2. Remove the drain plug (1). Allow the fuel to drain
from the filter. Check the O ring seal on the drain
plug for damage . If necessary, replace the O ring.
3. Remove the secondary filter bowl (2) from the
assembly. Remove the filter element and the O
ring seal. Discard both items. Clean the filter bowl.
Illustration 46
Typical example
Note: The filter element for the secondary fuel filter is
different from the element for the primary fuel filter.
Ensure that the correct elements are installed into
the fuel system.
4. Ensure that the insert (4) is the same shape as
the tab (3).
5. Align the insert to the tab and install the element
into the filter bowl.
g01394652
Illustration 47
6. Install a new O ring seal (5). Lubricate the threads
on the bowl assembly with CV60889 Special
Lubricant.
7. Install the bowl assembly. Tighten the bowl
assembly to a torque of 80 N·m (59 lb ft). Install
the drain plug and tighten to the following torque
1.2 N·m (11 lb in).
8. Turn the valves for the fuel lines (if equipped) to
the ON position. Prime the fuel system. Refer to
the Operation and Maintenance Manual, "Fuel
System - Prime" for more information.
9. Remove the split fuel and dispose of the fuel
safely.
10. Operate the engine and check for fuel leaks.
g01394660
Maintenance Section
Fuel System Secondary Filter - Replace
75
g01394685