Fuel System Secondary Filter - Replace - Perkins 402F-05 Operation And Maintenance Manual

SEBU9064-08
Illustration 80
Typical example
Note: Do not fill the fuel filter with fuel. The fuel will
not be filtered and the fuel could be contaminated.
Contaminated fuel can damage your fuel system.
5. Assemble the following items: seal (5), filter
element (6) and casing (3).
6. Install the assembled items to the filter base (4).
7. Install the locking ring (2) to the filter head. Rotate
the locking ring in order to lock the assembly.
The fuel system will need to be primed after the new
filter is installed. Refer to Operation and Maintenance
Manual, "Fuel System - Prime".
Fuel System Secondary Filter -
Replace
(1000 Hour Service For Certain
Engines Only)
The constant speed engines model 403F-11 with
prefix EJ with prefix GJ can be configured to operate
with an extender fuel service. The extended fuel
service is for 1000 hours.
Fuel leaked or spilled onto hot surfaces or electri-
cal components can cause a fire. To help prevent
possible injury, turn the start switch off when
changing fuel filters or water separator elements.
Clean up fuel spills immediately.
Ensure that the engine is stopped before any servic-
ing or repair is performed.
Fuel Filter Replace
g01334895
1. Turn the fuel supply valve (if equipped) to the OFF
position before performing this maintenance.
2. Place a suitable container under the fuel filter to
catch any fuel that might spill. Clean up any spilled
fuel. Clean the outside body of the filter assembly.
Maintenance Section

Fuel System Secondary Filter - Replace

NOTICE
99
i06804036