Fluke 724 Calibration Manual page 27

Command Response/Actions
LOWER_MEAS
SIM
SIM?
Returns the simulate value in
Amps with units or none
V_RANGE
V_RANGE?
Returns the voltage range VOLTS
or MVOLTS
PULSE_FREQ
PULSE_FREQ?
Returns the pulse output
frequency with units.
FREQ_LEVEL
FREQ_LEVEL?
Returns the pulse output and
frequency output voltage 1-20V
TRIG
Toggles the pulse mode and
totalize trigger for read and
source.
TRIG?
Returns the state of the pulse
mode trigger, TRIGGERED,
UNTRIGGERED or NONE.
Table 5. Serial Command List-726 (cont.)
Arguments
1 argument, Valid
Modes:
DCI, DCMV, DCV,
TC, RTD,
FREQUENCY,
PULSE_TRAIN
1 Argument {value}
Multipliers u for micro,
m for milli, and k for
kilo are accepted.
A is for amps
1 Argument VOLTS or
MVOLTS
2 arguments
{number}{units}.
(units CPM ,Hz ,Khz)
1 Argument, valid
values: 1-20V
Command
Comment
Configures the
measurement
function. Sets
the specified
measure mode
If the value is
valid, this
command will
change modes
if necessary
and set the
output value to
{value} in that
mode.
Verify the SIM
output
Sets the
voltage range
Verify the
voltage range
Sets the pulse
output
frequency and
range
Verify the pulse
frequency
Sets the pulse
output and
frequency
output voltage
Verify the
frequency
voltage level
Initialize
totalized pulse
measurement
or output
Verify TRIG
state
Calibrators
Serial Command List (726)
Ch 1 Ch 2
X
X
X
X
X
X
X
X
X
X
X
19