Section 11 - Ordering Information And Mechanical Data; Additional Information - Motorola MC68360 User Manual

24. Typo on Figures 10-60 and 10-61.
On pages 10-70 and 10-71, in the middle of both Figures a reference bubble states RFCD
= 1. This should have been RFSD = 1.
Also on Figure 10-61, the heading for the top clock should be L1RCLK (FE=0, CE=1) and
the second clock should be L1RCLK (FE = 1, CE = 0).
Also on figures 10-60 and 10-62 had a spec. missing. Specification 88 should be shown
between the first rising edge of L1RCLK (FE=0, CE=0) and the rising edge of the L1RSYNC
pulse.
25. Typo on Figure 10-63.
On page 10-73, Figure 10-63, the first two headings for the clocks should have been
L1TCLK and not L1RCLK.
26. Typo on SCC in NMSI Mode Specification for 33MHz.
On page 10-75, Table 10.25, the specification for 33MHz was printed incorrectly. The fol-
lowing is the correct specification:
Num.
105 CTS1 Setup Time to TCLK1 Rising Edge
106 RXD1 Setup Time to RCLK1 Rising Edge
2 RXD1 Hold Time from RCLK1 Rising Edge
107
108 CD1 Setup Time to RCLK1 Rising Edge
Section 11 – ORDERING INFORMATION AND MECHANICAL DATA
1. Missing pin name for BGA.
On page 11-5, the pin name for pin R16 is missing. This pin should be labeled NC
2. Typo on CQFP dimension.
On page 11-6, The specification for G should have been 0.197 BSC not 0.019 BSC

Additional Information

1. Initialize the Dual port ram.
After Reset the dual port ram of the QUICC™ will come up at random setting. User should
always initialize the Dual port ram to ZERO after reset. This will prevent any unwanted bit to
be set in the dual port ram that may cause undesired result.
MOTOROLA
Freescale Semiconductor, Inc.
Characteristic
MC68360 USER'S MANUAL ERRATA
For More Information On This Product,
Go to: www.freescale.com
3.3 V or 5.0 V 5.0 V
25.0 MHz 33.34 MHz
Min Max Min Max
40 — 40 —
40 — 40 —
0 — 0 —
40 — 40 —
Unit
ns
ns
ns
ns
25