Table of Contents
Advertisement
11. Error in Signal Name.
On Page 7-73, section 7.8.4.5, the four strobe signal names L1STA1, L1STA2, L2STB1, and
L1STB2 in the SSEL1-SSEL4 should be replaced with L1ST1, L1ST2, L1ST3, and L1ST4.
12. Typo in SI Mode Register.
On page 7-81, section7.8.5.2, the bit definition of Grant Mode for TDM A or B has a typo and
should be replaced with the following text:
"1 = IDL mode. A GRANT mechanism is supported if the corresponding GR1-GR4 bits
in the SICR register are set. The grant is a sample of the L1GRx pin while
L1TSYNCx is asserted. This GRANT mechanism implies the IDL access controls
for transmission on the D channel. Refer to 7.8.6.2 IDL Interface Programming."
13. Typo on Time Slot Assigner Examples.
On pages 7-83 to 7-85, the acronym for frame sync delay was printed incorrectly. The
correct acronym is FSD, not SFD.
14. Typo in SI Status Register.
On page 7-87, section 7.8.5.5, first paragraph, second sentence, "The value of this register
is valid only when the corresponding bit in the SIGMR is clear." The acronym SIGMR should
have been SICMR.
15. Errata and missing note in GSMR
On page 7-113, the note under the description of CDP was not clear and should be replaced
with the following.
This bit must be set if this SCC is used in transparent mode and
must be cleared when used and non-transparent mode.
The same note should be added below the description of CTSP.
16. Clarification of TDCR—Transmit Divide Clock Rate Description.
One page 7-117, section 7.10.2, replace the second sentence of the TDCR description
beginning "If the DPLL is not used ..." with the following:
"To bypass the DPLL, choose the 1x value, except in asynchronous UART mode where
8x,16x, or 32x still must be used."
MOTOROLA
Freescale Semiconductor, Inc.
NOTE
MC68360 USER'S MANUAL ERRATA
For More Information On This Product,
Go to: www.freescale.com
11
Advertisement
Table of Contents
