AJA Ki Pro Ultra Control Manual page 9

2. 1 8. 0x20 0x30 – PreRoll
This command functions identically to the behavior outlined in the SRW-5500 9
pin protocol document.
2. 1 9. 0x20 0x42 – Auto Edit
This command initiates an auto edit. Please see the section below labeled "Editing"
for details on how editing functionality is implemented on the Ki Pro Ultra.
2.20. 0x20 0x60 – Full EE Off
This command has no real effect on the device. The device will, however, track the
state of Full EE in the "Full EE" status bit.
2.21. 0x20 0x61 – Full EE On
This command has no real effect on the device. The device will, however, track the
state of Full EE in the "Full EE" status bit.
2.22. 0x20 0x63 – Selected EE On
This command has no real effect on the device. The device will, however, track the
state of Selected EE in the "Selected EE" status bit. This bit will be cleared upon
edit completion.
2.23. 0x20 0x64 – Edit Off
This command stops an edit. There is a three frame delay between when the
edit off command is received and when the edit actually stops. Please see the
"Editing" section below for details on how editing functionality is implemented
on the Ki Pro Ultra.
2.24. 0x20 0x65 – Edit On
This command starts an edit. There is a three frame delay between when the
edit on command is received and when the edit actually starts. Please see the
"Editing" section below for details on how editing functionality is implemented
on the Ki Pro Ultra.
2.25. 0x24 0xE0 – Set Clip
This command sets the current clip index from the currently selected playlist. It
takes a four byte payload containing the 32 bit unsigned integer clip ID. The first
payload byte sent is the least significant byte of the 32 bit clip ID. This will cause
the device to cue up to the beginning of the set clip ID and go into still playback.
Ki Pro Ultra and Ki Pro Ultra Plus Machine Control Guide 9 www.aja.com