Status Data Byte 4, Bit 0 - Cue Up Complete; Status Data Byte 4, Bit 2 - Auto Edit; Status Data Byte 4, Bit 4 - Edit; Status Data Byte 4, Bit 5 - Full Ee - AJA Ki Pro Ultra Control Manual

3.26. Status Data Byte 4, Bit 0 – Cue Up Complete
This bit will be high when a cue up operation has completed. It will be cleared on
the start of a subsequent cue operation.
3.27. Status Data Byte 4, Bit 2 – Auto Edit
This bit will be high when auto edit has been started. It will be cleared by the
completion of the auto edit either by success or failure.
3.28. Status Data Byte 4, Bit 4 – Edit
This bit will be high when an edit operation has started. It will be cleared when
the edit operation has completed.
3.29. Status Data Byte 4, Bit 5 – Full EE
The device does not support full EE, however this bit will be set if the enable Full
EE On command has been sent. It will be cleared if the Full EE Off command has
been sent.
3.30. Status Data Byte 4, Bit 6 – Selected EE
d
3.31. Status Data Byte 8, Bit 3 – Color Frame Lock
This bit will be high whenever the device is in normal forward playback or record
and is rolling.
3.32. Status Data Byte 5, Bit 0 – Edit Preset A1
This bit reflects the A1 edit preset value set by the Edit Preset command. This
device has limited edit support. Please refer to the "Editing" section below for
further details.
3.33. Status Data Byte 5, Bit 1 – Edit Preset A2
This bit reflects the A2 edit preset value set by the Edit Preset command. This
device has limited edit support. Please refer to the "Editing" section below for
further details.
Ki Pro Ultra and Ki Pro Ultra Plus Machine Control Guide 19 www.aja.com