Usb Driver Installation; Windows Xp Installation - Bio-Logic VMP-300-based Installation And Configuration Manual

4- At this point in the installation
(Fig. 25), the user has to activate the
"Use the following IP address" box.
W :
ARNING THERE MIGHT BE ANOTHER
/
TCP IP PROTOCOL
" /
TCP IP DISTANT ACCESS
!
ON THIS LINE
5- Enter the PC IP address,
ENTER A NETWORK
automatically be added) and click on
the OK button.
W :
ARNING IP ADDRESSES MUST BE UNIQUE
IN A NETWORK
6- Restart the PC. Now the PC and the
INSTRUMENT are in the same
network.

3.5 USB driver installation

The instrument can use a USB connection to exchange data with the PC. This connection
requires USB drivers to be installed in the computer operating system. Installation of the drivers
will vary depending upon the operating system of the computer.
We highly recommend that the user works with at least Windows
potentiostat through a USB connection.

For other Windows
the CD-Rom. In this window select the automatic installation of the software.

3.5.1 Windows XP installation

The way to proceed to install USB drivers is described below for Windows
connecting the instrument to the computer with the USB cable power on the instrument. When
the user powers on the instrument, Windows automatically detects a new USB device. Then
the following installation window appears:
INSTALLED CALLED
",
DO NOT CLICK
DO NOT
(it will
MASK
versions, the user will probably have to specify where to find the driver on
Manual for VMP300-based instruments
Fig. 25: TCP/IP properties window.

2000 to control the

XP Pro. After
25